All wheel fittings are considered to be “safety critical” items as they perform a very important task. They keep the vehicle’s
wheels safely and securely attached to the vehicle while allowing easy removal in the event of a puncture or servicing
requirements.

With this in mind it is of the utmost importance that any parts we supply you with, that are to be used to fit wheels to any
vehicle, are the correct specification. This is your responsibility as the seller of the parts to the end user. If you have any doubts about these parts you should seek advice from a qualified mechanic.

Before buying any of our products you must do the following:
• Make sure that the vehicle’s wheel brace has the same hex head size as the nuts or bolts you are selling so in the event of a puncture the wheel brace will fit the nuts or bolts and allow the wheel to be removed.
• Tighten all nuts or bolts to car manufacturer’s recommended torque setting. This information can be found in the vehicle handbook.
• Do not over tighten. Do not use an air gun.
• Always apply the handbrake at all times when working on a vehicle.
• Check the tightness of all nuts or bolts after the first 100 miles and periodically check tightness of all nuts or bolts. Basic safety regulations and common sense should be used.
• If in doubt do not fit our wheel accessories until you have been given the correct advice.
• All weights, sizes & measurements stated are approximate

Click here for the Locking Wheel Nuts & Bolts Specification List (PDF)

 Due to our stringent security procedures replacement keys for the EVO MK5, Microlock or Triolock can only be ordered using the card supplied in each pack of locks. This card provides all the details you will need to order a replacement key.