You must make sure you are aware of the following important safety information.When fitting wheel spacers please note the following:

1. Before fitting wheel spacers make sure that you remove any dirt or rust deposits from the wheel hub. Make sure that this surface is free and clean from any debris.

2. Ensure that the spacer can be fitted tight up against the wheel hub (see fig 1). There must be no protrusions on the hub from nuts, bolts, clips etc.

3. You must make sure that when the spacer is fitted that the wheel and tyre will not foul the suspension or the bodywork. This is very important that this is checked before the vehicle moves.

4. Make sure that any nuts or bolts supplied with any wheel spacers fit the vehicle and are the correct length and seat.

5. You must advise your customers that by fitting spacers, longer wheel bolts or a wheel stud conversion may be required.

6.When the spacers are fitted you must make sure that there is a minimum of 8 full turns on the wheel nuts or bolts when tightened.

7. Use basic safety rules at all times, please read page 3.